Why 8UN on the large sizes
ASME B16.5 flange studs of 1-1/8 in and above normally use the 8-thread series (8UN) rather than the coarser UNC pitch. A mixed list therefore carries two thread series, and both have to be gauged.
Customer case · Malaysia
A petrochemical plant in Malaysia sent a mixed list of flange stud bolt sizes. HEXVARO supplied ASTM A193 Grade B7 full-thread studs, each with two ASTM A194 Grade 2H heavy hex nuts, coated with zinc-nickel plating under a PTFE topcoat, and shipped the order by container.
Quantities and prices stay between HEXVARO and the customer.
Selected lines. Length in millimetres; each line supplied as sets of one stud and two heavy hex nuts.
| Diameter – TPI | Series | Lengths (mm) |
|---|---|---|
| 1/2 in-13 | UNC | 60, 65, 70, 85 |
| 5/8 in-11 | UNC | 85, 90, 110, 120, 180 |
| 3/4 in-10 | UNC | 110, 115, 120, 130 |
| 7/8 in-9 | UNC | 115, 130, 150 |
| 1-1/8 in-8 | 8UN | 150, 205 |
| 1-5/8 in-8 | 8UN | 210, 300, 440, 680 |
| 2-1/2 in-8 | 8UN | 440 |
ASME B16.5 flange studs of 1-1/8 in and above normally use the 8-thread series (8UN) rather than the coarser UNC pitch. A mixed list therefore carries two thread series, and both have to be gauged.
The zinc-nickel layer gives the steel sacrificial corrosion protection. The PTFE topcoat adds a barrier layer, gives the colour, and lowers thread friction. Because the coating changes friction, tightening torque should follow the project procedure or the coating supplier's nut factor, not a dry-thread torque table.
Coated studs packed loose rub against each other and damage the coating on the thread crests. Each stud went into its own plastic net sleeve before boxing; the nuts were bagged and boxed separately.
Similar list?
Grade, diameter and thread series, length, nuts per stud, coating and quantity per line. MOQ 500 pcs per specification.